Effects of surface-mounted roughness on the water surface turbulent field
نویسندگان
چکیده
منابع مشابه
the effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
THE EFFECT OF OPACIFIERS ON SURFACE ROUGHNESS OFCERAMIC GLAZES
Surface smoothness of ceramic glazes is always an important characteristic of ceramic glazes as a point of surface engineering studies. Surface roughness affects chemical resistivity, glossiness and stainabiliy of glazes. In fact, less surface roughness improves cleanability of the surface by the least usage amount of detergents. In this investigation, surface topography of two common opaque gl...
متن کاملA comparetive study of the effects of home and office bleaching on enamel surface roughness
Introduction: Increase in enamel surface roughness after bleaching is one of its major side effects. The purpose of this study is to compare changes in enamel surface roughness following bleaching with home versus office bleaching agents. Materials and Methods: In this experimental study, forty human sound premolar teeth were divided into 4 groups, randomly. Ten teeth were bleached using hydrog...
متن کاملOptical remote sensing of surface roughness through the turbulent atmosphere.
Using a CO(2), cw, coherent lidar, we have measured the surface roughness of diffuse targets through 1000 m of turbulent atmosphere. The technique measures the phase fluctuations of the speckle field at the receiver and relates the measured phase variance to the surface roughness. Measurements were made with aluminum targets that had been sandblasted with 8-, 16-, and 30-grit material and also ...
متن کاملOn the Mechanism of Surface Roughness Wake Field Excitation*
In the manufacturing process beam pipes acquire a structure on their inner walls with a roughness depth in the order of typically 0.5 μm rms. This surface structure is polarised by the beam and can be interpreted as an artificial dielectric. The thin dielectric layer model shows, that for rough tubes there is exactly one synchronous mode, the so called “rough tube mode” (normally in the THz reg...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Visualization Society of Japan
سال: 2005
ISSN: 1884-037X,0916-4731
DOI: 10.3154/jvs.25.supplement2_31