Effects of Nose Radius, Cutting Ratio and Friction Coefficient on Chip Flow Direction in Single-Point-Tool Cutting

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effects of Friction and Cutting Speed on Cutting Force

Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...

متن کامل

Determination of workpiece flow stress and friction at the chip–tool contact for high-speed cutting

This paper presents a methodology to determine simultaneously (a) the flow stress at high deformation rates and temperatures that are encountered in the cutting zone, and (b) the friction at the chip–tool interface. This information is necessary to simulate high-speed machining using FEM based programs. A flow stress model based on process dependent parameters such as strain, strain-rate and te...

متن کامل

Influence of Cutting Edge Shape on Residual Stresses of Cut Surface* (Effects of Nose Radius and Cutting Edge Roundness)

In order to obtain basic information on the improving the surface integrity of machined surfaces, the relationship between the residual stress of cut surfaces and the cutting edge shapes of cutting tools was examined. Dry facing on a lathe was performed with cutting tools that had various nose radiuses and cutting edge roundnesses. The residual stresses of the cut surfaces were measured by X-ra...

متن کامل

Cutting-Tool Materials and Cutting Fluids

The reasons for the availability of a large variety of cutting-tool materials is best appreciated by reviewing the top eight parameters in the first column in Table 22.2 on p. 638. Among various factors, the type of workpiece material machined, the type of operation, and the surface finish and dimensional accuracy required all affect the choice of a cutting-tool material. For example, for inter...

متن کامل

the effects of changing roughness on the flow structure in the bends

flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Japan Society of Precision Engineering

سال: 1968

ISSN: 0374-3543

DOI: 10.2493/jjspe1933.34.135