Effects of Moderation in Adhesive Force between Tool and Chip with Surface Micro Textures on Reduction in Cutting Force
نویسندگان
چکیده
منابع مشابه
Modeling the Influence of Tool Deflection on Cutting Force and Surface Generation in Micro-Milling
In micro-milling, cutting forces generate non-negligible tool deflection, which has a significant influence on the machining process and on workpiece accuracy. This paper investigates the tool deflection during micro-milling and its effect on cutting force and surface generation. The distribution of cutting forces acting on the tool is calculated with a mathematical model that considers tool el...
متن کاملSurface Roughness, Machining Force and FlankWear in Turning of Hardened AISI 4340 Steel with Coated Carbide Insert: Cutting Parameters Effects
The current experimental study is to investigate the effects of process parameters (cutting speed, feed rate and depth of cut) on performance characteristics (surface roughness, machining force and flank wear) in hard turning of AISI 4340 steel with multilayer CVD (TiN/TiCN/Al2O3) coated carbide insert. Combined effects of cutting parameter (v, f, d) on performance outputs (Ra, Fm and VB) ar...
متن کاملFuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملthe effect of cutting speed on cutting force and surface quality in broaching of aluminum 7075
0
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2015
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.81.452