Effects of martensite morphology and tempering on dynamic deformation behavior of dual-phase steels
نویسندگان
چکیده
منابع مشابه
The Effect of Ferrite Grain Size on the Fatigue Behavior of Ferrite-martensite Dual-phase Steels
The effect of ferrite grain size on the fatigue and tensile properties of dual phase steels with a 0.25 volume fraction of martensite (Vm) under different heat treatments was investigated. The heat treatments were homogenized at 1200 oC along with several subsequent normalizations at 910 oC, resulting in different microstructures and mechanical properties. After heat treatment, the obtained ste...
متن کاملHigh Temperature Behavior of Dual Phase Steels
Dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500C. Stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500C, and smooth flow at the other temperatures. Both yield and ultimate tensile strengths increased with increasing testing temperature up to about 450<sup...
متن کاملthe effect of ferrite grain size on the fatigue behavior of ferrite-martensite dual-phase steels
the effect of ferrite grain size on the fatigue and tensile properties of dual phase steels with a 0.25 volumefraction of martensite (vm) under different heat treatments was investigated. the heat treatments werehomogenized at 1200 oc along with several subsequent normalizations at 910 oc, resulting in differentmicrostructures and mechanical properties. after heat treatment, the obtained steels...
متن کاملGrain Refinement of Dual Phase Steel via Tempering of Cold-Rolled Martensite
A microstructure consisting of ultrafine grained (UFG) ferrite with average grain size of ~ 0.7 µm and dispersed nano-sized carbides was produced by cold-rolling and tempering of the martensite starting microstructure in a low carbon steel. Subsequently, fine grained dual phase (DP) steel consisting of equiaxed ferrite grains with average size of ~ 5 µm and martensite islands with average size ...
متن کاملThe Silicon Effect in the Tempering of Martensite in Steels
High-silicon steels have long been known to possess exceptional resistance to tempering, but the reasons for this effect were unknown. We report here a study of the third stage of tempering of these steels, in which cementite is formed. In a 0.75 wt% C 1.4 wt% Si alloy steel, tempered for 1 hour at 380°C, it is found that silicon atoms are rejected from the growing cementite into the ferrite ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgical and Materials Transactions A
سال: 2004
ISSN: 1073-5623,1543-1940
DOI: 10.1007/s11661-006-0217-5