Effects of holding temperature and holding time on pore structures in porous aluminum fabricated by friction stir processing
نویسندگان
چکیده
منابع مشابه
Effects of diluting medium and holding time on sperm motility analysis by CASA in ram
The aim of this study was to evaluate the effects of dilution rate and holding time on various motility parameters using computer-assisted sperm analysis (CASA). The semen samples were collected from three Ghezel rams. Samples were diluted in seminal plasma (SP), phosphate-buffered saline (PBS) containing 1% bovine serum albumin (BSA) and Bioexcell. The motility parameters that computed and rec...
متن کاملEffect of temperature on handgrip holding time.
The effect of intramuscular temperature upon the holding time of 70% MVC handgrip contraction was studied in 12 college-age men. The intramuscular temperature was regulated by 30 minutes immersion of the forearm and hand in a waterbath at 18 degrees C, 35 degrees C, or 45 degrees C. Elevating intramuscular temperature significantly reduced the holding time duration, (25.7 +/- 6.2 vis 38.3 +/- 8...
متن کاملTHE EFFECT OF HOLDING TIME ON TEMPERATURE EUTECTIC UNDERCOOLING IN DUCTLIE IRON
In the present research influences of different combinations of five types of inoculants and four types of nodularizers on eutectic nucleation in ductile cast iron were studied. The alloys were kept at 1320°C for 0, 5, 10, 15 and 20 min under nitrogen atmosphere. Cooling curves and image analysis were used to characterize the influence of holding time and different combinations of inoculants an...
متن کاملCharacterization of Aluminum-Based-Surface Matrix Composites with Iron and Iron Oxide Fabricated by Friction Stir Processing
Surface composite layers were successfully fabricated on an A 1050-H24 aluminum plate by dispersed iron (Fe) and magnetite (Fe₃O₄) particles through friction stir processing (FSP). Fe and Fe₃O₄ powders were packed into a groove of 3 mm in width and 1.5 mm in depth, cut on the aluminum plate, and covered with an aluminum sheet that was 2-mm thick. A friction stir processing (FSP) tool of square ...
متن کاملFriction Stir Processing of Aluminum Alloys: A Literature Survey
Many aluminum alloys with specific properties, like high strength, suffers from certain limitations in terms of cost and time of production, apart from the reduction in ductility. High strength accompanied by high ductility is possible with materials having fine and homogenous grain structures. Hence there arises a necessity to develop a processing technique that would produce a material with s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2009
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.59.642