Effects of Hard Chromium Plating on Cavitation Erosion
نویسندگان
چکیده
منابع مشابه
Alternatives to hard chromium plating on piston rods
As a main part of hydraulic cylinder, the piston rod is used in tough surrounding and corrosive condition; consequently a high quality protecting layer is essential. Currently EHC, electroplating hard chromium (hard chrome) is a widespread method for piston rod due to powerful performance and low cost. Unfortunately the plating process contains hexavalent chromium (Cr) which is toxic and carcin...
متن کاملComparison of cavitation erosion rate with liquid impingement erosion rate
Both cavitation erosion and liquid impingement erosion are phenomena that can cause pipe wall thinning in power plants. The Code for Power Generation Facilities, Rules on Pipe Wall Thinning Management, was published by the JSME (Japan Society of Mechanical Engineers) in 2005. The code says that cavitation erosion shall be prevented either in the design stage or by daily inspection. On the other...
متن کاملWaste Minimization in Chromium Plating Industry Waste Minimization in Chromium Plating Industry
Membrane electrolysis (ME) is the only commercial technology using ion-exchange membranes for chromic acid recycling and recovery. On one hand, the technology has a number of promising advantages, but on the other hand, it has not yet gained common acceptance probably due to a lack of operation stability and efficiency. Published results of the research can be divided into three categories: lab...
متن کاملObservations of cavitation erosion pit formation.
Previous investigations showed that a single cavitation bubble collapse can cause more than one erosion pit (Philipp & Lauterborn [1]). But our preliminary study showed just the opposite - that in some cases a single cavitation pit can result from more than one cavitation event. The present study shows deeper investigation of this phenomenon. An investigation of the erosion effects of ultrasoni...
متن کاملTowards numerical prediction of cavitation erosion.
This paper is intended to provide a potential basis for a numerical prediction of cavitation erosion damage. The proposed method can be divided into two steps. The first step consists in determining the loading conditions due to cavitation bubble collapses. It is shown that individual pits observed on highly polished metallic samples exposed to cavitation for a relatively small time can be cons...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1987
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.53.2203