Effects of Alumina Hydrates Formed by Hydration of Hydraulic Alumina on Green Strength and Microstructure of Porous Alumina Ceramics
نویسندگان
چکیده
منابع مشابه
Hertzian Contact Damage in Porous Alumina Ceramics
A study has been made of Hertzian contact damage in compressive shear stress field beneath the contact area. The observed microcrack density increases with grain size, porous and dense liquid-phase-sintered aluminas. Indentation stress–strain curves show increasing nonlinearity as the implying a threshold microstructural scale for crack initiation. In contrast, the micromechanisms controlling f...
متن کاملSurface Contamination of Alumina Ceramics by Carbon
Article history: Received: 01.05.2016. Received in revised form: 25.07.2016. Accepted: 06.09.2016. This study presents the results of investigating the cause of contamination of aluminum oxide ceramics (Al2O3) in the form of brown colored stain. Contaminated ceramic surfaces were examined with the scanning electron microscope (SEM) equipped with the Energy Dispersive Spectrometer (EDS). The res...
متن کاملMullite-alumina functionally gradient ceramics
Cracks free mullite-alumina Functionally Gradient Ceramics (FGC) have been obtained by sequential slip casting of Mullite-alumina slurries with diserent mullite/alumina ratios. These slurries were prepared with 65 % solids content and viscosities rangingpom 10 to 40 mPa.s. 7he presence of cracks perpendicular to the FGC layers have been attributed to residual stresses developed because of the m...
متن کاملPorous Alumina Films with Width-Controllable Alumina Stripes
Porous alumina films had been fabricated by anodizing from aluminum films after an electropolishing procedure. Alumina stripes without pores can be distinguished on the surface of the porous alumina films. The width of the alumina stripes increases proportionally with the anodizing voltage. And the pores tend to be initiated close to the alumina stripes. These phenomena can be ascribed to the e...
متن کاملThe synthesis of alumina nanowires on the surface of a porous alumina membrane
Porous aluminum oxide membranes with a complete and even covering of alumina nanowires were formed in a one-step anodization process in dilute phosphoric acid electrolyte. The anodizing conditions can be adjusted to start forming alumina wires that originate on the surface of the porous alumina layer at the triple junction points (the edges of the hexagonal inter-pore structure where three pore...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2006
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.114.214