Effectof Surface Morphology on Adhesive Strength
نویسندگان
چکیده
منابع مشابه
Effectof Dentin Cleansers on the Bonding Eflicacy of Dentin Adhesive
The relatlon between the bonding eMcacy ef the dentin adhesive and the physical change of the dentin after treatment with various dentin cleansers was investigated, The dentin surface was cleaned with one of the seven experimental dentin cleansers, 5, 10, 20, 30 and 40% of the phosphoric acid, neutralized O,5M EDTA solution (pH7.4) and 9.1% pyruvic acid containing 9,1% glycin, prior to the comb...
متن کاملAdhesive Bonding Lap Shear Strength Improvement of Cfr(peek) Laminates by Surface Morphology Modifications
In this paper, an experimental study concerning the effect of surface morphology on mechanical properties of adhesive bonding behaviour of continuous carbon fibres reinforced PEEK was performed. Surface morphology of PEEK composite was varied by sandblasting process. 3D morphological parameters were calculated from interferometry measurements. Surface wettability behaviour was studied by depose...
متن کاملEffect of Enamel and Dentin Surface Treatment on the Self-Adhesive Resin Cement Bond Strength.
The aim of this study was to evaluate the effect of enamel and dentin surface treatment on the micro-shear bond strength of self-adhesive cement. Seventy-two extracted third molars had their crowns embedded in acrylic resin and worn to obtain a flat enamel or dentin surface. The enamel and dentin specimens were randomly assigned to 8 groups (n=12) that were based on surface treatment (11.5% pol...
متن کاملInfluence of Surface Treatments and Adhesive Systems on Lithium Disilicate Microshear Bond Strength.
The purpose of this study was to evaluate the microshear bond strength of ceramic prosthetic structures reinforced by lithium disilicate cemented with resin cement under conditions of different surface treatments and adhesive systems. Seventy-two rectangular blocks of lithium disilicate (6.5 mm long × 5 mm wide × 1 mm thick) were fabricated, air abraded with 50-μm Al2O3 particles and divided in...
متن کاملEffect of dentinal surface preparation on bond strength of self-etching adhesive systems.
The aim of this study was to evaluate the effects of dentin surface treatments on the tensile bond strength (TBS) of the self-etching primer Clearfil SE Bond (CSE) and the one-step self-etching One-Up Bond F (OUB). The exposed flat dentin surfaces of twenty-four sound third molars were prepared with diamond bur at high-speed, carbide bur at low-speed or wet ground with #600 grit SiC paper. The ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Adhesion Society of Japan
سال: 2013
ISSN: 0916-4812,2187-4816
DOI: 10.11618/adhesion.49.244