Effect on Auto-Ignition and Knock with Furans Addition
نویسندگان
چکیده
منابع مشابه
Imaging and Analysis of Auto-Ignition and Heavy Knock in a Full Bore Optical SI Engine
The work involved a fundamental study of auto-ignition under unusually high knock intensities for an optical spark ignition engine. The single-cylinder research engine adopted included full bore overhead optical access capable of withstanding continuous peak in-cylinder pressures of up to 150bar. A heavy knock was deliberately induced under relatively low loads using inlet air heating and a pri...
متن کاملExperimental and Numerical Study on Effect of Sample Orientation on Auto-Ignition and Piloted Ignition of Poly(methyl methacrylate)
In this work, the effect of seven different sample orientations from 0° to 90° on pilot and non-pilot ignition of PMMA (poly(methyl methacrylate)) exposed to radiation has been studied with experimental and numerical methods. Some new and significant conclusions are drawn from the study, including a U-shape curve of ignition time and critical mass flux as sample angle increases for pilot igniti...
متن کاملThe effect of hydrogen and nitrogen addition on heavy duty diesel engine emissions under reactivity controlled compression ignition combustion
The aim of this study is to evaluate a heavy duty diesel engine operation under reactivity controlled compression ignition combustion fueled with diesel oil and natural gas enriched with hydrogen and nitrogen addition. In this study, a single cylinder heavy– duty diesel engine is set to operate at 9.4bar gross IMEP (Mid- Load). The amount of injected diesel oil per cycle into the engine combust...
متن کاملImproved Knock Detection Method Based on New Time-Frequency Analysis In Spark Ignition Turbocharged Engine
Premature combustion that affects outputs, thermal efficiencies and lifetimes of internal combustion engine is called “knock effect”. However knock signal detection based on acoustic sensor is a challenging task due to existing of noise in the same frequency spectrum. Experimental results revealed that vibration signals, generated from knock, has certain frequencies related to vibration resonan...
متن کاملInvestigation of Auto Ignition Condition under Different Parameters
In this work, the potential of auto-ignition of heavy oil during in-situ combustion (ISC) process was studied. Kinetic studies were carried out using Thermo Gravimetric Analyzer (TGA), Differential Scanning Calorimetry (DSC) and Accelerating Rate Calorimetric (ARC) techniques. Effects of oxygen partial pressure, reservoir pressure and clay on auto ignition condition were investigated on a n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2011
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.77.1259