Effect of tin level on microstructure of tin-doped indium oxide
نویسندگان
چکیده
منابع مشابه
Functionalization of indium tin oxide.
The preparation and functionalization of ITO surfaces has been studied using primarily X-ray photoemission spectroscopy and infrared reflection-absorption spectroscopy (IRRAS) and the reagents n-hexylamine and n-octyltrimethoxysilane (OTMS). Particular attention has been paid to characterization of the surfaces both before and after functionalization. Surfaces cleaned by ultraviolet (UV)/ozone ...
متن کاملEnhanced Physical Properties Of Indium Tin Oxide Films Grown on Zinc Oxide-Coated Substrates
Structural, electrical and optical properties of indium tin oxide or ITO (In2O3:SnO2) thin films on different substrates are investigated. A 100-nm-thick pre-deposited zinc oxide (ZnO) buffer layer is utilized to simultaneously improve the electrical and optical properties of ITO films. High purity ZnO and ITO layers are deposited with a radio frequency sputtering in argon ambient with plasma p...
متن کاملHydrogen-doped indium oxide/indium tin oxide bilayers for high-efficiency silicon heterojunction solar cells
The front transparent conductive oxide layer is a source of significant optical and electrical losses in silicon heterojunction solar cells because of the trade-off between free-carrier absorption and sheet resistance. We demonstrate that hydrogen-doped indium oxide (IO:H), which has an electron mobility of over 100 cm/V s, reduces these losses compared to traditional, low-mobility transparent ...
متن کاملIndium Tin Oxide@Carbon Core–Shell Nanowire and Jagged Indium Tin Oxide Nanowire
This paper reports two new indium tin oxide (ITO)-based nanostructures, namely ITO@carbon core-shell nanowire and jagged ITO nanowire. The ITO@carbon core-shell nanowires (~50 nm in diameter, 1-5 μm in length,) were prepared by a chemical vapor deposition process from commercial ITO nanoparticles. A carbon overlayer (~5-10 in thickness) was observed around ITO nanowire core, which was in situ f...
متن کاملMorphology-Controlled Indium Oxide Nanostructures that Grow Vertically on Fluorine-Doped Tin Oxide
heat treated In2O3 nanowalls using FULLPROF. [1] A Thompson-Cox-Hastings pseudo-Voigt profile function was used to simulate the In2O3 as well as the SnO2 phase resulting from the FTO substrate. Preferred orientation has been taken into account in all refinements. The final Rietveld refinement plots are shown in Figure 2c-d in the main text. The FTO substrate in both patterns showed a strong pre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Crystallographica Section A Foundations of Crystallography
سال: 2008
ISSN: 0108-7673
DOI: 10.1107/s0108767308082585