Effect of Structural State on Tendency Towards Stress Corrosion Cracking of Ultralow-Carbon Martensitic and Low-Alloy Pipe Steels
نویسندگان
چکیده
Mechanical properties as well crack resistance and stress corrosion cracking (SCC) parameters of ultralow-carbon martensite steels (ULMS) type 05H2G2B HSLA pipe steel 10G2FB with a different structures depending on processing are investigated. It is shown that despite higher strength level, SCC ULMS 25–30% than for ferrite-perlite structure close to this subjected quenching tempering.
منابع مشابه
Stress Corrosion Cracking Resistance of Martensitic Stainless Steels for Transmutation Applications
متن کامل
Stress Corrosion Cracking and Hydrogen Embrittlement of Martensitic Alloy EP-823
...................................................................................................................... iii TABLE OF CONTENTS ................................................................................................... iv LIST OF TABLES ............................................................................................................ vii LIST OF FIGURES ............
متن کاملEffect of Hydrogen on Corrosion and Stress Corrosion Cracking of AZ91 Alloy in Aqueous Solutions
The effect of hydrogen on the corrosion and stress corrosion cracking of the magnesium AZ91 alloy has been investigated in aqueous solutions. Hydrogen produced by corrosion in water diffuses into, and reacts with the Mg matrix to form hydride. Some of the hydrogen accumulates at hydride/Mg matrix (or secondary phase) interfaces as a consequence of slow hydride formation and the incompatibility ...
متن کاملthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولEffect or Inoculation on Microstructure and Properties of Low C-Mn and Low Alloy Steels
Effect of the addition of various inoculants on the morphology and mechanical properties of low C-Mn and low alloy steel samples is studied by thermal and mechanical processing of the samples after solidification. According to the results obtained from metallographic studies with the electron microscope and microanalysis with x-rays, the distribution of inoculating agents in the steel matrix is...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgist
سال: 2021
ISSN: ['1573-8892', '0026-0894']
DOI: https://doi.org/10.1007/s11015-021-01113-0