Effect of sintering time on microstructure and electrical properties of varistor ceramics ZnO-CoO-SLS glass

نویسندگان

چکیده

The influence of sintering time on the microstructure and electrical properties ZnO-CoO-SLS (soda lime silica) glass varistor based ceramics has been investigated. With increased time, density sintered pellets from 5.060 to 5.644 g/cm3 resulting in an increase nonlinear coefficient barrier height 6.742 8.252 0.846 0.955 eV, respectively. breakdown voltage is inversely proportional leakage current. increases 183.7 278.6 V/cm current decreases 5.832 4.324 ?A/cm2 as 60 150 minutes but their value 222.8 5.078 ?A/cm2. high nonlinearity 7.366 with lowest achieved at minutes, 0.954 eV.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Influence of Adding SiC on Microstructure and Electrical Properties of ZnO-based Nanocomposite Varistor

In this research the influence of adding SiC on microstructure and electrical properties of ZnO-based Nanocomposite varistors were investigated. SiC was added with amounts of 10-0 mass% to ZnO-based varistor composition. It is found that SiC allows reaching to high threshold voltage with formation of fine-graine...

متن کامل

influence of adding sic on microstructure and electrical properties of zno-based nanocomposite varistor

in this research the influence of adding sic on microstructure and electrical properties of zno-based nanocomposite varistors were investigated. sic was added with amounts of 10-0 mass% to zno-based varistor composition. it is found that sic allows reaching to high threshold voltage with formation of fine-grained zno.another important effect of adding sic is formation zn2sio4 (willemite) on the ...

متن کامل

Sintering Behavior and Properties of Iron-Rich Glass-Ceramics

Iron-rich glass-ceramics were obtained by the sintering of two glass powders, labeled G1 and G2, at heating rates of 5° and 20°C/min followed by an isothermal step in the 850°–1050°C temperature interval. The sintering process was evaluated by the linear shrinkage; the closed porosity was estimated by density measurements; the structure and the morphology of the glass ceramics were observed by ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Science of Sintering

سال: 2021

ISSN: ['0350-820X', '1820-7413']

DOI: https://doi.org/10.2298/sos2104509i