Effect of Si Content in Steel on Formation of Fe-Zn Intermetallic Compound Layer at Pure Zn Melt/Steel Interface
نویسندگان
چکیده
منابع مشابه
REACTION KINETICS OF THE FORMATION OF INTERMETALLIC Fe – Zn DURING HOT - DIP GALVANIZING OF STEEL
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – Institute of Chemical Technology, Prague, Czech Republic This review article mainly describes the composition of intermetallic Fe Zn, i.e. zeta (ζ), delta (δ1k + δ1p), gamma1 (Γ1) and gamma (Γ) on galvanized steel during low temperature galvanization (t ~ 450 °C). It gives detail...
متن کاملthe washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولElectron Diffraction Study on Fe–Zn intermetallic Phase of a Galvannealed IF Steel Sheet
In order to investigate the structure of Fe–Zn phase in a commercial galvannealed IF steel sheet, the electron diffraction and composition of phase in a commercial galvannealed IF steel sheet were studied by transmission electron microscope (TEM) and X-ray energy dispersive spectroscopy (EDX). The cross-sectional TEM specimen was prepared using focused ion beam (FIB) technique which was also in...
متن کاملControl of Formation of Intermetallic Compound in Dissimilar Joints Aluminum-steel
The elimination of the FexAly type phases was considered the solution to low ductility presented in aluminum-steel welded joints. Recently, the researches do not seek the suppression but the control of the thickness of these compounds. In this work, Al-Fe joints were manufactured by solid state and fusion welding, looking for controlling the formation of intermetallic comp...
متن کاملTribological Behaviour of Fe-Al Intermetallic Compound Coated Carbon Tool Steel
The use of Fe-Al intermetallic compound coatings has been investigated in order to improve the tribological behaviour of carbon tool steel. The coatings were formed by a pack cementation process and subsequently diffusion annealing at 900˚C in an argon controlled atmosphere. The optimum diffusion time was selected on the basis of optimum thickness and tribological behaviour. The microstructure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2014
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.100.390