Effect of rotational speed and tool pin profile on the corrosion rate of friction stir welded AA6061-T3
نویسندگان
چکیده
منابع مشابه
Effect of Tool Rotational Speed on the Tensile and Microstructural Properties of Friction Stir Welded Different Grades of Stainless Steel Joints
Friction stir welding is a relatively new solid state joining process, which is suitable for welding similar and dissimilar materials. The present research work concentrates on the effect of tool rotational speed on the tensile, microstructural properties and microhardness of the friction stir welded joints of different grades of austenitic stainless steel sheets. Four different tool rotationa...
متن کاملEffect of Tool Speed on Axial Force, Mechanical Properties and Weld Morphology of Friction Stir Welded Joints of A7075-T651
The axial force measurement plays important role in tool designing and identification of its restrictions. Also, it is vital in design of machine mechanism and optimization of welding process parameters. In this study, a friction stir welded butt join on AA7075-T651 aluminum alloy plate is investigated. With change of some parameters, factors including axial force, mechanical properties, microh...
متن کامل: the effect of sericin levels (silk glue protein) on rate of in vitro maturation, fertilization and culture of sheep oocytes
هدف از آزمایش اول بررسی اثر سطوح مختلف سریسین [0 (control), 0.1, 0.5, 1.0, 2.5 %] افزوده شده به محیط , ivm بر cumulus cell expansion، بلوغ هسته و توسعه متوالی جنین، در گوسفندان نژاد سنجابی در فصل تولید مثلی می باشد. از سرگیری میوز به وسیله خارج شدن اولین پولار بادی اندازه گیری و هم چنین درصد رسیدن جنین های دو سلولی به مرحله کلیواژ و بلاستوسیت نیز به عنوان نشانه ای از میزان شایستگی توسعه اولیه ج...
Analytical Investigations of the Effects of Tool Pin Profile and Process Parameters on the Peak Temperature in Friction Stir Welding
In this work, effects of different tool pin profiles of flat and tapered shoulder geometries on the peak temperature in friction stir welding are investigated analytically. The developed models used for the analytical investigations considered the welding process as a combination or mixture of the pure sliding and the pure sticking. From the results, the amount of heat generation and the peak t...
متن کاملInfluence of rotational speed on the development of microstructure in a friction stir welded 304 austenitic stainless steel
Friction stir welding was conducted on AISI 304 austenitic stainless steel sheet with dimensions of 100 mm × 100 mm × 2 mm. The FSW was performed at a welding speed of 150 mm/min and rotational speeds of 400 and 800 rpm. The results showed that high frequency of low angle grain boundaries (LAGBs) were formed through dynamic recovery in the thermo-mechanically affected zone (TMAZ). Higher amoun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/1090/1/012124