Effect of Insert Angles on Cutting Tool Geometry
نویسندگان
چکیده
منابع مشابه
effect of oral presentation on development of l2 learners grammar
this experimental study has been conducted to test the effect of oral presentation on the development of l2 learners grammar. but this oral presentation is not merely a deductive instruction of grammatical points, in this presentation two hypotheses of krashen (input and low filter hypotheses), stevicks viewpoints on grammar explanation and correction and widdowsons opinion on limited use of l1...
15 صفحه اولCutting Tool Geometry Suggestions Based on a Fuzzy Logic Model
This work is about a fuzzy logic model in order to suggest an initial cutting tool geometry for each work-tool material combination. The Takagi-Sugeno-Kang model was used to design the fuzzy system that was trained with suggested empirical cutting tool geometry values. The system inputs are the specific cutting energy of the work material and the ratio of the quadratic bending strength over mod...
متن کاملInfluence of the Tool Edge Geometry on Specific Cutting Energy at High- Speed Cutting
This paper presents specific cutting energy measurements as a function of the cutting speed and tool cutting edge geometry. The experimental work was carried out on a vertical CNC machining center with 7,500 rpm spindle rotation and 7.5 kW power. Hardened steels ASTM H13 (50 HRC) were machined at conventional cutting speed and high-speed cutting (HSC). TiN coated carbides with seven different g...
متن کاملOptimization of Cutting Insert Geometry Using Deform-3d: Numerical Simulation and Experimental Validation
In this research work an attempt has been made to minimize flank wear of uncoated carbide inserts while machining AISI 1045 steel by finite element analysis. Tool wear is the predominant factor that causes poor surface finish and is responsible for the dimensional accuracy of the machined surface. The quality of component produced decides the effectiveness and competitiveness of any manufacturi...
متن کاملEffect of Tool Shoulder and Pin Cone Angles in Friction Stir Welding using Non-circular Tool Pin
In friction stir welding frictional heat is generated by the rotating tool, sliding over the stationary plate along the weld centre. Tool being the only source of heat producing member, its geometrical design influences the heat generation rate. In this present work, effects of variation in tool shoulder and tool pin taper angles on thermal history during joining are analysed. Tools with triang...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Sciences
سال: 2020
ISSN: 2414-9381,2312-2498
DOI: 10.21272/jes.2020.7(2).a1