Effect of injection molding conditions on morphology of binary polymer blends
نویسندگان
چکیده
منابع مشابه
Morphology and Mechanical Properties Investigation of Binary Polymer Blends Based on PP/SEBS and PP/PC
In this study, eight binary blends of polypropylene (PP)/ poly [styrene-b-(ethylene-co butylene)-b-styrene] tri-block copolymer (SEBS) and polypropylene (PP)/ polycarbonate (PC) were produced at different composition through twin screw extruder. The composition of the minor phases was changed to correlate the morphology and mechanical properties of binary blends (PP/PC and PP/SEBS) through ther...
متن کاملthe effect of taftan pozzolan on the compressive strength of concrete in the environmental conditions of oman sea (chabahar port)
cement is an essential ingredient in the concrete buildings. for production of cement considerable amount of fossil fuel and electrical energy is consumed. on the other hand for generating one tone of portland cement, nearly one ton of carbon dioxide is released. it shows that 7 percent of the total released carbon dioxide in the world relates to the cement industry. considering ecological issu...
effect of oral presentation on development of l2 learners grammar
this experimental study has been conducted to test the effect of oral presentation on the development of l2 learners grammar. but this oral presentation is not merely a deductive instruction of grammatical points, in this presentation two hypotheses of krashen (input and low filter hypotheses), stevicks viewpoints on grammar explanation and correction and widdowsons opinion on limited use of l1...
15 صفحه اولThe Effect of Injection Molding Temperature on the Morphology and Mechanical Properties of PP/PET Blends and Microfibrillar Composites
Within this research the effect of injection molding temperature on polypropylene (PP)/poly(ethylene terephthalate) (PET) blends and microfibrillar composites was investigated. Injection molding blends (IMBs) and microfibrillar composites (MFCs) of PP/PET have been prepared in a weight ratio 70/30. The samples were processed at three different injection molding temperatures (Tim) (210, 230, 280...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korea Academia-Industrial cooperation Society
سال: 2008
ISSN: 1975-4701
DOI: 10.5762/kais.2008.9.1.165