Effect of homogenizing treatment on type of Al-Fe-Si phases in 6063 aluminum alloy ingots.
نویسندگان
چکیده
منابع مشابه
the washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولModification of Primary Si Crystals and Fe-rich Intermetallics in LM28 Al Alloy Fabricated Through Thixoforming
In the present research, thixoforming route was carried out in order to enhance the microstructural features of LM28 piston alloy. Typical microstructure of this alloy was composed of coarse, polygonal primary silicon particles, eutectic matrix and intermetallic phases. Thermal analysis was carried out to study the solidification path of the base alloy and determine the major arrest temperature...
متن کاملEffects of Heat Treatment on Strength and Ductility of Rolled and Forged Aluminum 6063 Alloy
This work examines the effect of heat treatment on tensile strength and ductile responses of rolled and forged AA6063 aluminum alloy. Some cast samples were rolled while some were forged at ambient temperature (32C). The deformed samples were subjected to heat treatment processes. The tensile strengths of rolled (212 MPa) and forged (127 MPa) samples are enhanced at ambient temperature but with...
متن کاملeffect of oral presentation on development of l2 learners grammar
this experimental study has been conducted to test the effect of oral presentation on the development of l2 learners grammar. but this oral presentation is not merely a deductive instruction of grammatical points, in this presentation two hypotheses of krashen (input and low filter hypotheses), stevicks viewpoints on grammar explanation and correction and widdowsons opinion on limited use of l1...
15 صفحه اولEffect of Die Entry Angle on Extrusion Responses of Aluminum 6063 Alloy
Mechanical properties response of extruded 6063 aluminum alloy at varied die entry angle has been investigated. Plain carbon and tool steel dies with entry angles of 15, 30, 45, 60, 75 and 90 were simulated. Extrusion on the alloy was done at ambient temperature (37C) and the extruded samples from the various angles were subjected to selected service related mechanical tests and microstructural...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1998
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.48.489