Effect of flat minor cutting edge tool in precision finish turning.
نویسندگان
چکیده
منابع مشابه
On-Line Estimation of Groove Wear in the Minor Cutting Edge for Finish Machining
The paper investigates the effective detection and esdmation of = m v e wear at the minor cutting edge, which has a mtal influence on surface quality in finish-machining. During bar-turning experiments with different cutting conditions, a miniature 3-D accelerometer, mounted in close vicinity to the tool tip, was used to measure the multivariate vibration signal produced by the turning process....
متن کاملEvaluation of Flank Wear of Iron-rich Binder Carbide Cutting Tool in Turning of Titanium Alloy
Despite the fact that Titanium material has been considered as difficult to cut material, its usage has been increasing day by day in all engineering sectors; wherever criticality is encountered. Many studies are going on in view of increasing tool life at high cutting speed to improve productivity. In this study, attempt has been made to see the effect of iron as a partial substitution along ...
متن کاملCutting tool wear estimation for turning
The experimental investigation on cutting tool wear and a model for tool wear estimation is reported in this paper. The changes in the values of cutting forces, vibrations and acoustic emissions with cutting tool wear are recoded and analyzed. On the basis of experimental results a model is developed for tool wear estimation in turning operations using Adaptive Neuro fuzzy Inference system (ANF...
متن کاملEffects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and forces in finish turning of hardened AISI H13 steel
In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1988
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.54.2331