Effect of FeO Content on Foaming and Viscosity Properties in FeO-CaO-SiO2-MgO-Al2O3 Slag System

نویسندگان

چکیده

The foaming process is an important part of the electric arc furnace (EAF) steelmaking process. It can promote thermal efficiency and reduce refractory consumption. FeO a key material used during Unlike with other components in forming slag, amount be controlled by oxygen or carbon injection. Therefore, adjusting content most economical mode adopted for EAFs In this study, influence on physical properties slag was discussed. melting temperature evaluated using three methods: viscosity experiment, Thermo-Calc simulation software, high-temperature optical method. experimental results revealed that increases as decreases. also foam height ratio exhibited positive correlation slag.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Melting Behaviour of Model Lherzolite in the System CaO–MgO–Al2O3–SiO2–FeO at 0·7–2·8 GPa

Fe–Mg exchange is the most important solid solution involved in for Fe–Mg exchange between the coexisting crystalline phases and melt, KdFe–Mg, show a relatively simple and predictable behaviour partial melting of spinel lherzolite, and the system CaO– MgO–Al2O3–SiO2–FeO (CMASF) is ideally suited to explore with pressure and temperature: the coefficients for olivine and spinel do not show signi...

متن کامل

Thermodynamic simulation on mineralogical composition of CaO–SiO2–Al2O3–MgO quaternary slag system

It is necessary to elucidate the crystallization thermodynamic of mineralogical phases during the cooling process of the molten BFS with different chemical composition, because the high-melting point mineral phase maybe crystallized during the fiber forming and thereafter cooling process. Thermodynamic calculation software FactSage6.4 and the hot remelting experiments were performed to explore ...

متن کامل

Equations of state of FeO and CaO

New shock-wave (Hugoniot) and release-adiabatic data for Feo.940 and CaO, to 230 and 175 GPa (2.3 and 1.75 Mbar) respectively, show that both oxides transform from their initial B1 (NaC1-type) structures at about 70 (* 10) GPa. CaO transforms to the B2 (CsC1-type) structure and FeO is inferred to do the same. Alternatively, FeO may undergo an electronic transition, but it probably does not disp...

متن کامل

Measuring and Modeling Viscosity of CaO-Al2O3-SiO2(-K2O) Melt

The effect of K2O on viscosity in CaO-SiO2-Al2O3 melt has been measured by a rotating spindle viscometer. It is indicated from the experimental results that viscosity first increases then decreases with the increasing content of K2O; the maximum viscosity occurs in the field of K2O/ Al2O3 > 1. After gradually adding K2O, the transformation of bridging oxygen (from being bonded with Al ion charg...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Metals

سال: 2021

ISSN: ['2075-4701']

DOI: https://doi.org/10.3390/met11020289