Effect of electrode material on electrical discharge machining of tool steel surface
نویسندگان
چکیده
منابع مشابه
Fatigue Life of Graphite Powder Mixing Electrical Discharge Machining AISI D2 Tool Steel
The present paper deals with the design of experimental work matrices for two groups of experiments by using Response surface methodology (RSM). The first EDM group was dealt with the use of kerosene dielectric alone, while the second was treated by adding the graphite micro powders mixing to dielectric fluid (PMEDM). The total heat flux generated and fatigue lives after EDM and PMEDM models we...
متن کاملModeling the machining parameters of AISI D2 tool steel material with multi wall carbon nano tube in electrical discharge machining process using response surface methodology
This work investigates the machining characteristics of American Iron and Steel Institute (AISI) D2 tool steel with copper as a tool electrode during electrical discharge machining (EDM) process. The multi wall carbon nano tube (MWCNT) is mixed with dielectric fluids in EDM process to analyze the surface characteristics of surface roughness. Regression model were developed to predict the surfac...
متن کاملInvestigation of the effect of Process Parameters on Surface Roughness in Wire Electric Discharge Machining of En31 Tool Steel
Modernization of mechanical industry has lead to the increase in demand for hard and tough materials and thus various non traditional methods have been developed in order to machine such hard and tough materials. Wire Electric discharge machine is one of the most commonly used machine which is employed in machining of conductive metals of any hardness or that are difficult or impossible to cut ...
متن کاملPrediction of surface roughness in Electrical Discharge Machining of SKD 11 TOOL steel using Recurrent Elman Networks
Elman Networks is a one of the dynamic recurrent neural networks. In this research it is used for the prediction of surface roughness in Electrical Discharge Machining (EDM). Training of the models was performed with data from series of EDM experiments on SKD 11 (AISI D2) Tool steel; in the development of predictive models, machining parameters of discharge current, pulse duration and duty cycl...
متن کاملthe study of the effect of input parameters on material romoval rate, %tool water ratio and surface roughness of aisi h13 tool steel in the electrical discharge machining (edm)
in this study the effect of input parameters of the edm process (pulse on-time, duty cycle and tool polarity), on the material removal rate (mrr), tool wear ratio (twr) and maximum surface roughness (rmax) in the machining aisi h13 tool steel has been studied. this study shows that increasing the duty cycle in the two conditions of tool polarity, material removal rate and the maximum surface ro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Ain Shams Engineering Journal
سال: 2015
ISSN: 2090-4479
DOI: 10.1016/j.asej.2015.02.001