Effect of Cutting Point Swivel Machining by Using Tool with Special Chamfer
نویسندگان
چکیده
منابع مشابه
Machining with Minimal Cutting Fluid
The purpose of cutting fluid in a machining operation is to cool the workpiece, reduce friction, and wash away the chips. The cutting fluid contributes significantly toward machining cost and also possesses environmental threats. In the past, there have been some attempts to minimize the amount of cutting fluid in machining. This chapter reviews some prominent ways to minimize the application o...
متن کاملEffect of Dry Cutting on Force and Tool Life When Machining Aerospace Material
Cutting fluids, usually in the form of a liquid, are applied to the chip formation zone in order to improve the cutting conditions. Cutting fluid can be expensive and represents a biological and environmental hazard that requires proper recycling and disposal, thus adding to the cost of the machining operation. For these reasons dry cutting or dry machining has become an increasingly important ...
متن کاملCutting Tool Temperature Analysis in Heat-Pipe Assisted Composite Machining
Machining of advanced materials, such as composite, encounters high cutting temperatures and rapid tool wear because of the abrasive nature of the reinforcement phases in the workpiece materials. Ultrahard coatings, such as chemical vapor deposition diamond, have been used for machining such advanced materials. Wear of diamond-coated tools is characterized by catastrophic coating failure, plaus...
متن کاملOptical Effect of Surface Finish by Single Point Diamond Machining
Although ultraprecision diamond turned optics can have surface roughness down to tens of nanometers or even lower, they may still contain defects due to machining process variations. Diamond turned surfaces have been carefully studied before [3-12]. The previous research however was mainly focused on the causes of the surface texture and one of the main goals of these studies was to improve the...
متن کاملThe Orthogonal Machining Process Using Cutting Tools with Different Geometry
This paper deals with modelling of the orthogonal machining process using tools with different geometries. The finite element method (FEM) is used for a simulation based on the Lagrangian formulation including ANSYS/LS-DYNA software. The constitutive Johnson – Cook material model regarding strain, strain rate and temperature to predict material plasticity and chip separation is used. Chip morph...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2012
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.78.705