Effect of Cu on the Microstructure and Mechanical Properties of Diecast Al-Mg<sub>2</sub>Si-Mg Based Alloy
نویسندگان
چکیده
منابع مشابه
Influence of Rolling Temperature on Microstructure and Mechanical Properties of Cryorolled Al-Mg-Si Alloy
An effect of rolling temperature on the mechanical properties and microstructural evolution of an Al-Mg-Si alloy was studied. The material was rolled up to a true strain of ∼0.7 at three different temperatures viz; room temperature, liquid propanol and liquid nitrogen. The liquid nitrogen rolled sample exhibited superior properties with a yield and tensile strength of 332 MPa and 364 MPa, respe...
متن کاملthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولthe effect of genre-based teaching on reading comprehension of literary texts
تحقیق حاضر به بررسی کاربرد روش ژانر-محور را در محیط آموزش زبان عمومی می پردازد.روش ژانر-محور به زبان آموزان کمک میکند که در زمینه خوانش پیشرفت کنند. بعضی از محققین معتقد اند که روش تدریس ژانر-محور به تدریج به زبان آموزان کمک می کند تا در درک ژانر های مختلف مهارت یابند (هایلند 2004).همچنین امروزه توجه روز افزونی به اهمیت استفاده از ادبیات در برنامه آموزشی زبان انگلیسی (esl/efl ) شده است. زمانی ک...
15 صفحه اولEffect of Al–5Ti–C Master Alloy on the Microstructure and Mechanical Properties of Hypereutectic Al–20%Si Alloy
Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...
متن کاملEffect OF SI and AL on the Microstructure, Mechanical Properties and Machinability of 65CU-35ZN Brass
Relations between the microstructure, mechanical properties and machinability of as-cast 65Cu-35Zn brass with various amounts of Al from 0 to 4.72 and Si from 0 to 3.62 wt% were investigated. Both Si and Al initially enhanced the UTS and toughness of the brass samples, which led to improvement in machinability due to a reduction in the main cutting force. A duplex brass with random oriented α p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science Forum
سال: 2014
ISSN: 1662-9752
DOI: 10.4028/www.scientific.net/msf.794-796.172