Effect of Cone Shape Condenser Plate Tilt Angle on Solar Still Productivity

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Improvement of Solar Still Productivity by Energy Absorbing Plates

A solar still is a viable option when the demand of potable water does not exceed more than 3 litres. Enhancement in distillate output from the solar still is a main goal of many researchers all over the world. In this research, the effect of copper and aluminium plates on distillate output is investigated experimentally as well as theoretically at different water depths under the same climate ...

متن کامل

The Possibility of using Flat Plate Solar Collector Based on the Best Calculated Tilt Angle in the City of Rasht as a Case Study (TECHNICAL NOTE)

The possibility of using flat plate collector in northern parts of Iran specially city of Rasht has been investigated in this paper. According to the high humidity in the northern parts of this country, diffuse radiation plays a more important role than direct radiation. This fact can change the results of delivered solar energy and the best tilt angle of the collector compared to the sunny cen...

متن کامل

Influence of Tilt Angle and Grinding Angle of the Plate on Friction and Transfer Layer Formation

In the present investigation, unidirectional grinding marks were attained on the steel plates. Experiments were then conducted using pins of high purity Al, pure Mg and Al-Mg alloys against the prepared steel plates using an inclined pin-on-plate sliding tester. The inclination angle of the plate was varied in the tests and for each inclination angle, the pins were slid both perpendicular and p...

متن کامل

Estimating Solar Radiation and Developing Iran’s Atlas Map of Optimum Monthly Tilt Angle (TECHNICAL NOTE)

Iran has great potential in utilizing solar energy. In order to maximize the amount of absorbed solar radiation to absorber surfaces, the surfaces should be installed at a suitable angle slope to the horizon that is discussed in this article. The calculations performed in this study was done using MATLAB software. In this study, radiation received on the ground in 31 provincial capitals of the ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IOP Conference Series: Earth and Environmental Science

سال: 2020

ISSN: 1755-1315

DOI: 10.1088/1755-1315/616/1/012038