Effect of Al and Cu Contents on Mechanical Properties of Au-Cu-Al Shape Memory Alloys
نویسندگان
چکیده
منابع مشابه
Shape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملMagnetoelasticity and Magnetoresistance in Cu–Al–Mn Shape-Memory Alloys
This paper is aimed at studying the effect of a magnetic field on the martensitic transition of a Cu–Al–Mn shape-memory alloy. The martensitic transition has been studied through resistance measurements under applied magnetic fields ranging from 0 to 50 kOe. Negative magnetoresistance showing an almost linear dependence with the square of the magnetization has been observed. This magnetoresisti...
متن کاملEffect of Ta Additions on the Microstructure, Damping, and Shape Memory Behaviour of Prealloyed Cu-Al-Ni Shape Memory Alloys
The influence of Ta additions on the microstructure and properties of Cu-Al-Ni shape memory alloys was investigated in this paper. The addition of Ta significantly affects the green and porosity densities; the minimum percentage of porosity was observed with the modified prealloyed Cu-Al-Ni-2.0 wt.% Ta. The phase transformation temperatures were shifted towards the highest values after Ta was a...
متن کاملStabilization and Two Way Shape Memory Effect in Cu-Al-Mn Alloys Transforming at Elevated Temperatures
Stabilization of martensite and two way shape memory effect (TWSME) was studied in Cu-Ai-Mn alloys containing 9.7-11.8 wt% Al, and 3.0-9.25 wt% Mn, which were quenched to various temperatures. The transforming temperatures were in the range -70 to +220°C. The majority of alloys quenched directly to martensite did not show reverse transformation on heating due to stabilization and further temper...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 2015
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet.jb201511