Effect of Ageing on Shape Memory Effect and Transformation Temperature on Cu-Al-Be Shape Memory Alloy
نویسندگان
چکیده
منابع مشابه
Shape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملAging behavior in Cu–Al–Be shape memory alloy
This article reports positron annihilation spectroscopy and calorimetric measurements of the aging behavior in a Cu–Al–Be shape memory alloy. An excess of single vacancies is retained in the alloy as a result of a quench. All vacancies in excess disappear after long aging time, and a migration energy EM51.060.1 eV for this process has been found to be larger than in other Cu-based shape memory ...
متن کاملThe change of transformation temperature on NiTi shape memory alloy by pressure and thermal ageing
We have investigated the effect of pressure and thermal ageing on transformation behavior of Ni-%45.16Ti shape memory alloy. 70-320 MPa pressure was applied and annealed at 500 o C for 2 hour to see the effect of applied pressure on transformation temperature. It was observed that the starting and final temperature of austenit increased, the martensite start temperature almost remain constant a...
متن کاملshape memory properties in cu-zn-al alloy
in this research a cu-zn-al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. the optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, ti on the grain size and the shape memory properties of the samples are investigated. solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Materials Science
سال: 2014
ISSN: 2211-8128
DOI: 10.1016/j.mspro.2014.07.301