Effect of adding iron to the AlSi7Mg0.3 (EN AC 42 100, A356) alloy
نویسندگان
چکیده
منابع مشابه
Porosity Prediction in Aluminum A356 Alloy Castings
A comprehensive methodology that takes into account alloy solidification, shrinkage-driven interdendritic fluid flow, hydrogen precipitation, and porosity evolution has been developed for the prediction of microporosity fraction in aluminum A356 alloy castings. The mathematical models presented are implemented in a computational framework consistent with those of commercial casting codes, allow...
متن کاملSoldering of Aluminum Matrix Composites Sicp/a356 and Kovar Alloy
Article history: Received 28.3.2013 Received in revised form 26.4.2013 Accepted 29.4.2013 Aluminum matrix composites containing 55% SiC particle reinforcing phase/SiC reinforcement phase particle and Kovar alloy 4J29 were chosen as the base metals. After nickel plating on the surface of SiCp/Al, two kinds of materials were soldered together by using Zn-Cd-Ag-Cu as the filler metal and ZnCl2 as ...
متن کاملEffect of Reheating to the Semisolid State on the Microstructure of the A356 Aluminum Alloy Produced by Ultrasonic Melt-Treatment
The effect of reheating to the semisolid state (soaking treatment) on the microstructure evolution of the A356 aluminum alloy prepared by ultrasonic melt treatment was studied in this paper. The results showed that in general the longer the soaking process the larger and the more round the grains obtained. Higher roundness occurs at shorter soaking times in the fine-grained ascast samples, and ...
متن کاملPorosity Control and Fatigue Behavior in A356-T61 Aluminum Alloy
Much work has been done, in recent years, to characterize the factors that cause porosity in aluminum castings, and to analyze the impact of porosity or microstructural parameters on fatigue life. What has yet to be done is systematically separate out the effects of dendrite arm spacing and largest pore size from each other, and from the underlying chemical and process parameters that influence...
متن کاملEffect of Solution Treatment Temperature on Microstructure and Mechanical Properties of A356 Alloy
Over the years, aluminum content in a vehicle part is increasing due to the needs to reduce weight as well as increase fuel efficiency. Most of the cast product in a vehicle part is mostly cast from A356 alloy. It is used because A356 alloy posses’excellent characteristics over other type of alloy such as cast ability, high weight-to-strength ratio, good corrosion resistance and good weld-abili...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2013
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2013/a/1213-2489/mt/13/3/276