Edgeless silicon sensors fabricated without support wafer
نویسندگان
چکیده
منابع مشابه
Gated Silicon Drift Detector Fabricated from a Low-Cost Silicon Wafer
Inexpensive high-resolution silicon (Si) X-ray detectors are required for on-site surveys of traces of hazardous elements in food and soil by measuring the energies and counts of X-ray fluorescence photons radially emitted from these elements. Gated silicon drift detectors (GSDDs) are much cheaper to fabricate than commercial silicon drift detectors (SDDs). However, previous GSDDs were fabricat...
متن کاملNovel Silicon n-on-p Edgeless Planar Pixel Sensors for the ATLAS upgrade
In view of the LHC upgrade phases towards HL-LHC, the ATLAS experiment plans to upgrade the inner detector with an all-silicon system. The n-on-p silicon technology is a promising candidate for the pixel upgrade thanks to its radiation hardness and cost effectiveness. The edgeless technology would allow for enlarging the area instrumented with pixel detectors. We report on the development of no...
متن کاملHydrophobic silicon wafer bonding
Wafers prepared by an HF dip without a subsequent water rinse were bonded at room temperature and annealed at temperatures up to 1100 “C. Based on substantial differences between bonded hydrophilic and hydrophobic Si wafer pairs in the changes of the interface energy with respect to temperature, secondary ion mass spectrometry (SIMS) and transmission electron microscopy (TEM), we suggest that h...
متن کاملLecture 21: Silicon wafer manufacturing
The first step in integrated circuit (IC) fabrication is preparing the high purity single crystal Si wafer. This is the starting input to the fab. Typically, Si wafer refers to a single crystal of Si with a specific orientation, dopant type, and resistivity (determined by dopant concentration). Typically, Si (100) or Si (111) wafers are used. The numbers (100) and (111) refers to the orientatio...
متن کاملTop-down fabricated silicon nanowire sensors for real-time chemical detection.
Silicon nanowire (SiNW) sensors have been developed by using top-down fabrication that is CMOS (complementary metal-oxide-semiconductor) compatible for resistive chemical detection with fast response and high sensitivity. Top-down fabrication by electron beam lithography and reactive ion etching of a silicon on insulator (SOI) substrate enables compatibility with the CMOS fabrication process, a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
سال: 2020
ISSN: 0168-9002
DOI: 10.1016/j.nima.2019.163176