Edge Isolation Effects on Silicon Solar Cells using a Laser Scribing Process

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Laser-assisted Shunt Removal on High-efficiency Silicon Solar Cells

Development of all-back-contact (ABC) silicon solar cells at the Australian National University (ANU), as part of a collaboration between Trina Solar and the Solar Energy Research Institute of Singapore (SERIS), is progressing, and 22.6% efficient ABC cells, based on the aperture-area of 13 cm 2 that excludes busbars, were recently fabricated at ANU. When measured using the 16 cm 2 aperture-are...

متن کامل

Study the Effect of Silicon Nanowire Length on Characteristics of Silicon Nanowire Based Solar Cells by Using Impedance Spectroscopy

Silicon nanowire (SiNW) arrays were produced by electroless method on polycrystalline Si substrate, in HF/ AgNO3 solution. Although the monocrystalline silicon wafer is commonly utilized as a perfect substrate, polycrystalline silicon as a low cost substrate was used in this work for photovoltaic applications. In order to study the influence of etching time (which affects the SiNWs length) on d...

متن کامل

Optimization of Uv Laser Scribing Process for Led Sapphire Wafers

Billions of LEDs are used today in traffic control, automotive headlights, flat panel display technology, mobile devices, back lighting, projection and general illumination applications. With the dramatic growth in LEDs, manufacturers are looking for technologies to increase production yield and decrease cost. Sapphire wafer singulation into miniature dies is one of the critical steps used in b...

متن کامل

Scribing of ITO-coatings using a Q-switched Nd:YAG laser

This paper describes the results of optimising three process variables (control factors) to achieve a narrow line width in laser engraving of ITO conductive coatings using the Taguchi technique of experimental design. The laser used is a NEC Q-switched continuous wave (CW) Nd:YAG laser operating at a wavelength of 1.064 μm. The three process variables explored are: Q-switch frequency, speed of ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: The Transactions of The Korean Institute of Electrical Engineers

سال: 2017

ISSN: 1975-8359

DOI: 10.5370/kiee.2017.66.5.851