Eddy current characterization of cold-worked AISI 321 stainless steel
نویسندگان
چکیده
منابع مشابه
Relaxation Peaks of Cold Worked 304l Stainless Steel
In this investigation internal friction of cold worked 304L austenitic stainless steel was measured and the new peaks (PlIP2,P3) were found. The height of those peaks increased with cold work degree. The temperature of the main peak P3 was 33513340K at the frequency of -1,000Hz. The activation energies and frequency factors were obtained from peak shift. The values were 0.4evl 0.4evl 0.6ev and ...
متن کاملEddy current detection of changes in stainless steel after cold reductions
Cold rolling of austenitic stainless steel results in increase of residual stresses, hardness, and tensile strength and dislocation density. We have studied the response of eddy current impedance to austenitic change, hardness and its lift off phase in stainless steels during cold reductions. A series of samples of austenitic stainless steel alloys were cold rolled and found that only percentag...
متن کاملThe Electrochemical Behavior of AISI 321 Stainless Steel in Alkaline Media
In this paper, the electrochemical behaviour of passive films formed on AISI 321 stainless steel (AISI 321) immersed in 0.1 M NaOH + 0.1 M KOH solution was evaluated by different electrochemical techniques. For this purpose, passive films were formed at open circuit potential for 1 to 12 hours and then electrochemical measurements were done. The polarization curves suggested that AISI 321 showe...
متن کاملMicro abrasion-corrosion of AISI 316L stainless steel
In this study, the synergistic effects of abrasion and corrosion on AISI 316L stainless steel have been investigated using a micro-abrasion test rig. A series of results from abrasioncorrosion tests conducted using the micro-abrasion rig are presented. AISI 316L stainless steel has been studied under both pure abrasion and abrasion-corrosion conditions simulated by either distilled water or 3.5...
متن کاملBiomaterial Studies on AISI 316L Stainless Steel after Magnetoelectropolishing
The polarisation characteristics of the electropolishing process in a magnetic field (MEP – magnetoelectropolishing), in comparison with those obtained under standard/conventional process (EP) conditions, have been obtained. The occurrence of an EP plateau has been observed in view of the optimization of MEP process. Up-to-date stainless steel surface studies always indicated some amount of fre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research and Technology
سال: 2018
ISSN: 2238-7854
DOI: 10.1016/j.jmrt.2018.07.002