منابع مشابه
Size effect in equal channel angular pressing (ECAP) process
The influence of the sample size (diameter while keeping the length constant) in equal channel angular pressing (ECAP) of pure aluminum is examined using finite element method (FEM) and experiment. Different sized aluminum rods were processed via ECAP and the effect of sample size on the strain homogeneity, process load, and the ratio of the friction to the total force were evaluated. The resul...
متن کاملNumerical and analytical investigation of an ultrasonic assisted ECAP process
One of the great challenges in the processing of materials using Equal Channel Angular Pressing (ECAP) is the high forming forces required to produce large shear deformation in the material. Researchers show that the friction forces between the die and the sample constitute a great part of the total forming forces. Recently, ultrasonic vibrations are successfully implemented into the ECAP proce...
متن کاملUltrasonic assisted-ECAP.
Equal channel angular pressing (ECAP) is one of the most prominent procedures for achieving ultra-fine grain (UFG) structures among the various severe plastic deformation (SPD) techniques. In this study, the effect of ultrasonic vibration on deformation behavior of commercial pure aluminum in the ECAP process is analyzed successfully using three dimensional (3D) by finite element methods (FEMs)...
متن کاملnumerical and analytical investigation of an ultrasonic assisted ecap process
one of the great challenges in the processing of materials using equal channel angular pressing (ecap) is the high forming forces required to produce large shear deformation in the material. researchers show that the friction forces between the die and the sample constitute a great part of the total forming forces. recently, ultrasonic vibrations are successfully implemented into the ecap proce...
متن کاملMicrostructure of Ultrafine- Grained Metals after Ecap
This paper was aimed at verification of functionality of the ECAP technology at extrusion of the copper, alluminium alloys and steel. Experiments were made on equipment, which is demonstrated in the Fig 1. Deformation forces were measured during extrusion, resistance to deformation was calculated and deformation speed was determined approximately. Analysis of structure was made with use of ligh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2006
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.55.37