EBSD Examination of Argon Ion Bombarded Ti-6Al-4V Samples Produced with DMLS Technology
نویسندگان
چکیده
منابع مشابه
Heat Treatment of Ti-6al-4v Produced by Lasercusing
LaserCUSING® is a selective laser melting (SLM) process that is capable of manufacturing parts by melting powder with heat input from a laser beam. LaserCUSING demonstrates potential for producing the intricate geometries specifically required for biomedical implants and aerospace applications. One main limitation to this form of rapid prototyping is the lack of published studies on the materia...
متن کاملFatigue of Ti-6Al-4V
Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...
متن کاملSolid-state foaming of Ti–6Al–4V by creep or superplastic expansion of argon-filled pores
Ti–6Al–4V foams are produced by the expansion of pressurized argon pores trapped in billets created by powder metallurgy. Pore expansion during thermal cycling (840–1030 C, which induces transformation superplasticity in Ti–6Al–4V) improves both the foaming rate (by reducing the flow stress) and the final porosity (by delaying fracture of the pores and subsequent escape of the gas), as compared...
متن کاملProcess Mapping, Fracture and Fatigue Behavior of Ti-6al-4v Produced by Ebm Additive Manufacturing
The present work was conducted as part of a larger America Makes funded project to begin to examine the effects of changes in process variables on the resulting microstructure and fracture and fatigue behavior of as-deposited Ti-6Al-4V. In addition to presenting initial results on process mapping of the electron beam powder bed process, the present work also documents the location-dependent pro...
متن کاملMicrostructure and mechanical behavior of Ti-6Al-4V produced by rapid-layer manufacturing, for biomedical applications.
The microstructure and mechanical behavior of simple product geometries produced by layered manufacturing using the electron beam melting (EBM) process and the selective laser melting (SLM) process are compared with those characteristic of conventional wrought and cast products of Ti-6Al-4V. Microstructures are characterized utilizing optical metallography (OM), scanning electron microscopy (SE...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Periodica Polytechnica Mechanical Engineering
سال: 2019
ISSN: 1587-379X,0324-6051
DOI: 10.3311/ppme.13821