Dynamics of static friction between steel and silicon
نویسندگان
چکیده
منابع مشابه
Dynamics of static friction between steel and silicon.
We conducted experiments in which steel and silicon or quartz are clamped together. Even with the smallest tangential forces we could apply, we always found reproducible sliding motions on the nanometer scale. The velocities we study are thousands of times smaller than in previous investigations. The samples first slide and then lock up even when external forces hold steady. One might call the ...
متن کاملStatic friction between silicon nanowires and elastomeric substrates.
This paper reports the first direct measurements of static friction force and interfacial shear strength between silicon (Si) nanowires (NWs) and poly(dimethylsiloxane) (PDMS). A micromanipulator is used to manipulate and deform the NWs under a high-magnification optical microscope in real time. The static friction force is measured based on "the most-bent state" of the NWs. The static friction...
متن کاملStatic friction between rigid fractal surfaces.
Using spheropolygon-based simulations and contact slope analysis, we investigate the effects of surface topography and atomic scale friction on the macroscopically observed friction between rigid blocks with fractal surface structures. From our mathematical derivation, the angle of macroscopic friction is the result of the sum of the angle of atomic friction and the slope angle between the cont...
متن کاملDynamics of transition from static to kinetic friction.
We propose a model for a description of dynamics of cracklike processes that occur at the interface between two blocks prior to the onset of frictional motion. We find that the onset of sliding is preceded by well-defined detachment fronts initiated at the slider trailing edge and extended across the slider over limited lengths smaller than the overall length of the slider. Three different type...
متن کاملMicrostructure and Mechanical Properties of the Friction Welded Joint between X53CrMnNiN219 and X45CrSi93 Stainless Steel
Dissimilar metals friction welding of austenitic–martensitic stainless steels is commonly used in order to manufacture engine valves in the automobile industry. In this study, X53CrMnNiN219 (austenitic stainless steel) and X45CrSi93 (martensitic stainless steel) valve steel rods were welded by friction welding process. The welded joint was then heat treated at 760 0C for 60 min. Mechanical prop...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the National Academy of Sciences
سال: 2008
ISSN: 0027-8424,1091-6490
DOI: 10.1073/pnas.0806174105