Dynamic Up-Sampling Network for Small Airplane Landing Gear Detection
نویسندگان
چکیده
منابع مشابه
The NASA Landing Gear Test Airplane
A tire and landing gear test facility has been developed and incorporated into a Convair 990 aircraft. The system can simulate tire vertical load profiles to 250,000 lb, sideslip angles to 15 degrees, and wheel braking on actual runways. Onboard computers control the preprogrammed test profiles through a feedback loop and also record three axis loads, tire slip angle, and tire condition. The ai...
متن کاملController design for a wall landing airplane
Plane perching on a wire has been demonstrated with success in laboratory conditions by [Cory & Tedrake, 2008]. The present paper focuses on designing a controller for a small wall landing glider. We use a simulator and a reinforcement learning algorithm in a coarsely discretized state-space to design an optimal control for the landing. Analysis of this policy allows us to deduce a simpler clos...
متن کاملSimulation of the Dynamic Behavior of Aircraft landing Gear Systems
Simulation and the resulting prediction of the dynamic behavior of an aircraft and its landing gear system during ground maneuvers is an essential part in the design process. A realistic estimation of unwanted oscillations, such as gear walk and shimmy, for the landing gear and whole aircraft can be readily obtained with an MBS-model. It is then possible to adjust the model for changes in the s...
متن کاملDetection of fatigue crack growth in aircraft landing gear
Preliminary testing of a complete landing gear under fatigue test has demonstrated the applicability of the test using Acoustic Emission (AE) resonant sensors attached to the outer surface of the landing gear assembly. Attenuation trials were conducted which confirmed that attenuation through the main casing is low and provided data for optimisation of sensor positioning. Background noise level...
متن کاملAircraft Landing Gear Design & Development
Landing gear is one of the critical subsystems of an aircraft. The need to design landing gear with minimum weight, minimum volume, high performance, improved life, and reduced life cycle cost have posed many challenges to landing gear designers and practitioners. Further, it is essential to reduce the landing gear design and development cycle time while meeting all the regulatory and safety re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2019
ISSN: 2169-3536
DOI: 10.1109/access.2019.2929940