Dynamic Strain-Induced Ferrite Transformation during Hot Compression of Low Carbon Si-Mn Steels
نویسندگان
چکیده
منابع مشابه
STRAIN INDUCED AUSTENITE-TO-FERRITE TRANSFORMATION BEHAVIOR OF PLAIN CARBON STEELS THROUGH SINGLE PASS ROLLING
In principal, a proper combination of strength and ductility is achieved through micro component refinement in steels. This is particularly empowered with ferrite refinement down to micron sizes in ferrite pearlite engineering steels. The latter is achieved through various well-defined methods in which strain induced transformation (SIT) has shown spectacular capabilities. In the present study,...
متن کاملTHE EFFECT OF STRAINING BEFORE AND DURING AUSTENITE TO FERRITE TRANSFORMATION ON THE FINAL CHARACTERISTICS OF SI-MN TRIP STEELS
TRIP (TRansformation- lnduced- Plasticity) behavior is a powerful mechanism to improve mechanical properties. The basis of TRIP phenomena is the transformation of retained austenite with optimum characteristics (volume fraction, stability, size and morphology) to martensite during deformation at room temperature. Accordingly, the first requirement to obtain desired TRIP effects is to produce an...
متن کاملULTRA FINE FERRITE FORMATION IN Si-Mn TRIP STEELS
Abstract: In the present investigation, the effects of thermomechanical processing parameters and the steel chemical composition on the ultra fine ferrite formation characteristics were studied. This was programmed relying on the capabilities of strain induced transformation (SIT) phenomenon and applying to different grades of Si-Mn TRIP (Transformation Induced Plasticity) steels. According...
متن کاملتاثیر ترکیب شیمیایی بر تحولات ریزساختاری فولادهای میکروآلیاژی در حین تغییر شکل گرم در منطقه دو فازی (آستنیت + فریت)
Laboratory hot torsion testing technique was carried out on one plain low carbon steel and two plain low carbon Nb and Nb-Ti micro alloyed steels to study the effects of chemical composition, micro alloying addition, on the dynamic softening and grain refinement of ferrite during warm deformation. Deformation schedule was conducted within two phase region (i.e. between Ar3-Ar1). The physical pr...
متن کاملeffect of ai on the hot deformation of ferrite in cu-mn steels.
effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2011
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.m2011117