Dynamic signal analyses in dry sliding wear tests
نویسندگان
چکیده
منابع مشابه
The role of dynamic recrystallization in dry sliding wear
• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website. • The final author version ...
متن کاملFinite-element modeling of dry sliding wear in metals
This paper is concerned with the calibration and validation of a finite-element model of dry sliding wear in metals. The model is formulated within a Lagrangian framework capable of accounting for large plastic deformations and history-dependent material behavior. We resort to continuous adaptive meshing as a means of eliminating deformation-induced element distortion, and of resolving fine fea...
متن کاملDry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملMonitoring of Dry Sliding Wear Using Fractal Analysis
Reliable online monitoring of wear remains a challenge to tribology research as well as to the industry. This paper presents a new method for monitoring of dry sliding wear using digital imaging and fractal analysis. Fractal values, namely fractal dimension and intercept, computed from the power spectrum of the images of a wearing surface, are adopted as indicators of the dynamic wear process. ...
متن کاملSurface morphology in engineering applications: Influence of roughness on sliding and wear in dry fretting
Influence of initial surface roughness on friction and wear processes under fretting conditions was investigated experimentally. Rough surfaces (Ra=0.15-2.52 μm) were prepared on two materials: carbon alloy (AISI 1034) and titanium alloy (Ti-6Al-4V). Strong influence of initial surface roughness on friction and wear processes is reported for both tested materials. Lower coefficient of friction ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Brazilian Society of Mechanical Sciences and Engineering
سال: 2003
ISSN: 1678-5878
DOI: 10.1590/s1678-58782003000300011