Dynamic Load Analysis of an Centrifugal Pump Axle using FSI Simulation
نویسندگان
چکیده
Abstract The mechanical characteristics of the impeller are important indicators that determine working pump. pump is subjected to periodic hydraulic loads during process. This load will cause dynamic deformation and shaft, thereby further affecting distribution fluid. Liquid-solid coupling used. Method, rated operating point centrifugal analyzed, it proved stress shaft meets requirements, which lays a foundation for formulation control strategy impeller.
منابع مشابه
Dynamic Analysis of Suspension Footbridges Using an Actual Pedestrian Load Model Compared with EUR23984 EN Requirements
The suspension footbridges are very flexible due to their geometrical structure; hence they may face severe vibration problems induced mainly by natural forces and pedestrians crossing. By exceeding a certain limit, these vibrations can disturb the serviceability of the bridge as well as health and safety of the structure and pedestrians. Therefore, standard design guidelines are sets of recomm...
متن کاملDesign and Performance Analysis of Centrifugal Pump
This paper deals with the design and performance analysis of centrifugal pump. In this paper, centrifugal pump is analyzed by using a single-stage end suction centrifugal pump. Two main components of a centrifugal pump are the impeller and the casing. The impeller is a rotating component and the casing is a stationary component. In centrifugal pump, water enters axially through the impeller eye...
متن کاملExperimental Study and Three-Dimensional Numerical Flow Simulation in a Centrifugal Pump when Handling Viscous Fluids
In this paper the centrifugal pump performances are tested when handling water and viscous oils as Newtonian fluids. Also, this paper shows a numerical simulation of the three-dimensional fluid flow inside a centrifugal pump. For these numerical simulations the SIMPLEC algorithm is used for solving governing equations of incompressible viscous/turbulent flows through the pump. The k-ε turbulenc...
متن کاملimpeller trimming of an industrial centrifugal viscous oil pump
abstract: impeller trimming is a proper way to alter the performance of centrifugal pump with a constant speed so as to meet the demand on the specified flow rate and head in pumping systems. the affinity law accounting for the impeller trimming is the key relation to determine the pump performance with a trimmed impeller. there seems no experimental study dealing with such an affinity law for ...
متن کاملDynamic centrifugal compressor model for system simulation
A dynamic model of a centrifugal compressor capable of system simulation in the virtual test bed (VTB) computational environment is presented. The model is based on first principles, i.e. the dynamic performance including the losses is determined from the compressor geometry and not from the experimentally determined characteristic performance curves. In this study, the compressor losses, such ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of physics
سال: 2023
ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']
DOI: https://doi.org/10.1088/1742-6596/2441/1/012053