Dynamic Friction and Wear in a Planar-Contact Encapsulated Microball Bearing Using an Integrated Microturbine
نویسندگان
چکیده
منابع مشابه
A rotary microactuator supported on encapsulated microball bearings
The development of a rotary microactuator supported on encapsulated microball bearings and driven by electro-pneumatic actuation is reported. The encapsulated bearing provides full support to an encased rotor, while an electro-pneumatic thrust balance is used to minimize rotor normal load. By minimizing normal load, bearing friction is reduced leading to increased speed and performance. Experim...
متن کاملModeling Contact Friction and Joint Friction in Dynamic Robotic Simulation Using the Principle of Maximum Dissipation
We present a unified treatment for modeling Coulomb and viscous friction within multi-rigid body simulation using the principle of maximum dissipation. This principle is used to build two different methods—an event-driven impulse-based method and a time stepping method—for modeling contact. The same principle is used to effect joint friction in articulated mechanisms. Experiments show that the ...
متن کاملMeasurement and Modeling of Dynamic Rolling Friction in Linear Microball Bearings
In prior work of the authors and co-workers, a vision-based system was developed for characterizing the tribological behavior of silicon-micromachined linear microball bearings. Plain difference methods introduce amplitude and/or phase distortion in computing the derivative signals (e.g., velocity and acceleration) based on the position snapshots. In this paper frequency-dependent amplitude and...
متن کاملA Triboscopic Investigation of the Wear and Friction of MoS2 in a Reciprocating Sliding Contact
Reciprocating sliding tests with ball-on-flat geometry were performed on a duplex coating at low speeds in moist air (RH=60%). The coating, 55 nm MoS2 on 35 nm of TiN, was deposited by ion-beam assisted deposition onto a steel substrate. Friction coefficient (μ) and electrical contact resistance (Rc) measurements were recorded at ~2μm intervals along the track; these spatially resolved measurem...
متن کاملDynamic evolution of interface roughness during friction and wear processes.
Dynamic evolution of surface roughness and influence of initial roughness (S(a) = 0.282-6.73 µm) during friction and wear processes has been analyzed experimentally. The mirror polished and rough surfaces (28 samples in total) have been prepared by surface polishing on Ti-6Al-4V and AISI 1045 samples. Friction and wear have been tested in classical sphere/plane configuration using linear recipr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Microelectromechanical Systems
سال: 2009
ISSN: 1057-7157,1941-0158
DOI: 10.1109/jmems.2009.2013407