Dynamic crushing of aluminum foams: Part II – Analysis

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Creep of aluminum syntactic foams

Aluminum syntactic foams with densities of 1.2–1.5 g/cm3 were deformed at 500 ◦C under constant uniaxial compressive stresses ranging from to 14 MPa. The foam creep behavior is characterized by a short primary stage and a long secondary stage where the strain rate is constant and inimum, followed by a tertiary stage at high stresses. The minimum strain rate varies with stress according to an ap...

متن کامل

Simulation of Foaming and Deformation for Composite Aluminum Foams

In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...

متن کامل

Dynamic and Thermal Properties of Aluminum Alloy A356/Silicon Carbide Hollow Particle Syntactic Foams

Aluminum alloy A356 matrix syntactic foams filled with SiC hollow particles (SiCHP) are studied in the present work. Two compositions of syntactic foams are studied for quasi-static and high strain rate compression. In addition, dynamic mechanical analysis is conducted to study the temperature dependent energy dissipation and damping capabilities of these materials. The thermal characterization...

متن کامل

Improving the energy absorption of closed cell aluminum foams

Closed cell aluminum foams have received much recent attention as energy absorbing materials on account of their ability to undergo extensive deformation at a relatively low stress called the plateau stress. Several studies describe the improvements in energy absorption to be obtained, relative to their empty counterparts, when foam filled tubes are crushed either quasi-statically or dynamicall...

متن کامل

Influence of Thermal Contact Resistance of Aluminum Foams in Forced Convection: Experimental Analysis

In this paper, the heat transfer performances of aluminum metal foams, placed on horizontal plane surface, was evaluated in forced convection conditions. Three different types of contacts between the sample and the heated base plate have been investigated: simple contact, brazed contact and grease paste contact. First, in order to perform the study, an ad hoc experimental set-up was built. Seco...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: International Journal of Solids and Structures

سال: 2014

ISSN: 0020-7683

DOI: 10.1016/j.ijsolstr.2013.11.020