Dynamic Compression Test of Ceramics Using Modified Compression Split Hopkinson Bar.

Advancements in the Split Hopkinson Bar Test

Stress Equilibrium in the Split Hopkinson Pressure Bar Test

The compressive split Hopkinson pressure bar (SHPB) technique allows the stresses on each end of the specimen to be measured individually. Results are presented showing a large difference between these end pressures, depending on specimen length and loading rate. The mechanisms responsible are shown to be a combination of inertial forces and non-uniform deformation due to wave propagation. Impl...

Using the split Hopkinson pressure bar to validate material models.

This paper gives a discussion of the use of the split-Hopkinson bar with particular reference to the requirements of materials modelling at QinetiQ. This is to deploy validated material models for numerical simulations that are physically based and have as little characterization overhead as possible. In order to have confidence that the models have a wide range of applicability, this means, at...

Dynamic recrystallization kinetics of AISI 403 stainless steel using hot compression test

In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...

Extending the Radar Dynamic Range using Adaptive Pulse Compression

The matched filter in the radar receiver is only adapted to the transmitted signal version and its output will be wasted due to non-matching with the received signal from the environment. The sidelobes amplitude of the matched filter output in pulse compression radars are dependent on the transmitted coded waveforms that extended as much as the length of the code on both sides of the target loc...