Dynamic Characterization of TiAl Intermetallic in Hot Compression
نویسندگان
چکیده
منابع مشابه
Dynamic recrystallization kinetics of AISI 403 stainless steel using hot compression test
In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...
متن کاملDynamic Recovery and Recrystallization During Hot-Working in an Advanced TiAl Alloy Dynamische Erholung und Rekristallisation während der Warmverformung in einer TiAl-Hochleistungslegierung
Intermetallic TiAl alloys are light-weight high-temperature materials and intended to partly replace Ni based alloys in jet engines. Due to difficult forming operations, component prices are high and limit the possible field of application. During hotworking, recovery and recrystallization effects determine the microstructural evolution and thereby the mechanical properties of the finished part...
متن کاملHIGH-TEMPERATURE FRACTURE AND FATIGUE RESISTANCE OF A DUCTILE b-TiNb REINFORCED g-TiAl INTERMETALLIC COMPOSITE
ÐThe high-temperature fatigue-crack propagation and fracture resistance of a model g-TiAl intermetallic composite reinforced with 20 vol.% ductile b-TiNb particles is examined at elevated temperatures of 650 and 8008C and compared with behavior at room temperature. TiNb reinforcements are found to enhance the fracture toughness of g-TiAl, even at high temperatures, from about 12 to 040 MPa m, a...
متن کاملHot Deformation Behavior and Pulse Current Auxiliary Isothermal Forging of Hot Pressing Sintering TiAl Based Alloys
This paper focuses on the fabrication of as-forged Ti46.5Al2Cr1.8Nb-(W, B) alloy via pulse current auxiliary isothermal forging (PCIF). The starting material composed of near gamma (NG) microstructure was fabricated by adopting pre-alloyed powders via hot pressing sintering (HPS) at 1300 °C. Isothermal compression tests were conducted at a strain rate range of 0.001-0.1 s-1 and a temperature ra...
متن کاملMicrostructures and Mechanical Properties of NiAl-(Cr) and TiAl-(Cr) Intermetallic Alloys
The oxidation resistant light weight aluminides: NiAl and TiAl with ordered
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1997
ISSN: 1155-4339
DOI: 10.1051/jp4:19973102