Dynamic Characteristics in The Cutting Operations with Small Diameter End Mills
نویسندگان
چکیده
منابع مشابه
Dynamic neural network approach for tool cutting force modelling of end milling operations
This paper uses the artificial neural networks (ANN’s) approach to evolve an efficient model for estimation of cutting forces, based on a set of input cutting conditions. Neural network algorithms are developed for use as a direct modeling method, to predict forces for ball-end milling operations. Prediction of cutting forces in ball-end milling is often needed in order to establish automation ...
متن کاملHistopathological characteristics of small diameter melanocytic naevi.
BACKGROUND/AIMS The clinical definition of an atypical naevus ("dysplastic naevus" or "naevus with architectural disorder and cytological atypia of melanocytes") stresses size larger than 5 mm in diameter as a major diagnostic criterion. Because malignant melanomas and their precursors may arise in smaller lesions, a histological study of melanocytic lesions smaller than 4 mm in diameter was co...
متن کاملTwo Phase Heat Transfer Characteristics in a Vertical Small Diameter Tube at Sub Atmospheric Pressure
Two-phase heat transfer is experimentally examined through vertical small diameter tubes, D =1.45 and 2.8 mm using water under a pressure of 50 to 81 kPa and a natural circulation condition. The pool boiling correlation by Stephan-Abdelsalam and the thermosyphon boiling correlation by Imura, et al. predict the measured experimental data in the 2.8 mm tube with an error of -30%. A large heat tra...
متن کاملThe Effect of Surface Roughness of End-Mills on Optimal Cutting Performance for High-Speed Machining
Developments in machine tools tend towards high speed technology, including high-speed machining (HSM) and high-speed cutting (HSC), especially in high speed end milling applications [1] and [2]. High speed technology applications in machine tools are characterised by a high feeding speed, low axial and radial cutting depth, increased metal removal rate, simplified processing, and reduced costs...
متن کاملTest tube systems with cutting/recombination operations.
We introduce test tube systems based on operations that are closely related to the splicing operation, i.e. we consider the operations of cutting a string at a specific site into two pieces with marking them at the cut ends and of recombining two strings with specifically marked endings. Whereas in the splicing of two strings these strings are cut at specific sites and the cut pieces are recomb...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Mechanical Design, Systems, and Manufacturing
سال: 2008
ISSN: 1881-3054
DOI: 10.1299/jamdsm.2.609