Dynamic calibration method for reactive gases
نویسندگان
چکیده
منابع مشابه
Dynamic Weighing Calibration Method for Liquid Flowmeters -a New Approach
In the last years, the PTB liquid flow group has been working on the development of a new method to calibrate liquid flowmeters under dynamics conditions [1,2]. Such a measurement principle is based on a dynamic weighing approach, which is able to reproduce the unit of mass flow several times, with the ultimate goal to reduce the calibration time, energy cost, and workload in liquid flow calibr...
متن کاملDynamic Calibration Method for Instrumented Laparoscopic Surgical Graspers
The prevalence of minimally invasive surgical (MIS) procedures is on the rise due to the promise of fewer complications; however, these surgeries are more technically difficult and require greater training than their traditional counterparts. To counteract this, surgeons undergo more training and utilize surgical simulators to gain experience without risking patients’ health. To increase the ac...
متن کاملCalibration of Area-Reduction Empirical Method for Dam Reservoir
The mathematical model of Area-Reduction empirical method is written through MATLAB software. Three periods of the hydrologic survey are required to run, calibrate and validatethe model. The Dez Dam, which is one of the most significant dams of the Middle East with three periods of hydrographic surveys in 1972, 2002 and 2011, has been chosen for the investigation. The annual average of the inpu...
متن کاملApplication of Dynamic Programming Method for Reactive Power Planning
A new approach for solving reactive power planning problem is presented, which is based on dynamic programming and the use of a sensitivity approach to obtain candidate buses for allocation of reactive power devices in power systems. Once the set of candidate buses has been defined, the program gives the location and size of the reactive sources needed to satisfy operating and security constrai...
متن کاملControl of the Reactive Sputtering Process Using Two Reactive Gases
Reactive sputtering when two reactive gases are used presents special problems. Both reactive gases affect the plasma conditions, which means that both affect common feedback control signals such as the cathode voltage and optical emission signals. Two reactive gases require that unique signals for each reactive gas be acquired and that control of each of the reactive gases is done separately. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Measurement Science and Technology
سال: 2019
ISSN: 0957-0233,1361-6501
DOI: 10.1088/1361-6501/ab4d68