Ductility improvement on Al67Ti25Mn8 intermetallic alloy via hot-working
نویسندگان
چکیده
منابع مشابه
AlNb intermetallic alloy
This investigation was conducted to ascertain the benefits of electropolishing after mechanical polishing for electron backscattered diffraction of a Ti 2 AlNb intermetallic Ti − 21Al − 29Nb (at.%) alloy containing the orthorhombic (O) and body-centered-cubic (BCC) phases. Electropolishing was performed at − 40 ° C in 6% H 2 SO 4 methanol solution. Atomic force microscopy was used to measure th...
متن کاملDuctility Improvement of an AZ61 Magnesium Alloy through Two-Pass Submerged Friction Stir Processing
Friction stir processing (FSP) has been considered as a novel technique to refine the grain size and homogenize the microstructure of metallic materials. In this study, two-pass FSP was conducted under water to enhance the cooling rate during processing, and an AZ61 magnesium alloy with fine-grained and homogeneous microstructure was prepared through this method. Compared to the as-cast materia...
متن کاملDevelopment of hard intermetallic coatings on austenitic stainless steel by hot dipping in an Al-Si alloy
The austenitic stainless steel was coated by dipping into a molten Al-12.4%Si alloy at 765oC. The effect of immersion times in the range of 60 to 900 s was investigated with respect to the phase nature, thickness, and microhardness. An uniform layer (~12 m) of Al12(Fe,Cr)3Si2 intermetallic with hexagonal crystalline structure is formed, irrespectively the immersion time. Microhardness of the c...
متن کاملMicrostructure and Tribological Properties of Mo–40Ni–13Si Multiphase Intermetallic Alloy
Intermetallic compounds are increasingly being expected to be utilized in tribological environments, but to date their implementation is hindered by insufficient ductility at low and medium temperatures. This paper presents a novel multiphase intermetallic alloy with the chemical composition of Mo-40Ni-13Si (at %). Microstructure characterization reveals that a certain amount of ductile Mo phas...
متن کاملIndentation creep studies of iron aluminide intermetallic alloy
Indentation creep behaviour of iron aluminide intermetallic (Fe–28Al–3Cr) was studied in the temperature range of 843–963 K. The hardness and the plasticity parameter were also calculated from room temperature to 1273 K. The variation of hardness with time showed that the stress exponent ðnÞ was weakly dependent on temperature. Thermal activation parameter-activation area and energy were also c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scripta Metallurgica et Materialia
سال: 1992
ISSN: 0956-716X
DOI: 10.1016/0956-716x(92)90551-o