Dry sliding wear behaviour of Ti-TiB-TiN<SUB align="right">x in-situ composite synthesised by reactive hot pressing
نویسندگان
چکیده
منابع مشابه
Microstructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملDRY SLIDING WEAR BEHAVIOUR OF STIR CAST LM 25/ZrO2 METAL MATRIX COMPOSITES
In the present study, an investigation into wear properties has been carried out to identify the influence of ZrO2 as the reinforcement material on the LM25 MMC composite. Aluminum LM25 is selected as the base material, and it is reinforced with varying proportions of 0, 3, 6, 9, 12 and 15% of zirconia (ZrO2) manufactured by stir casting. Six tensile test and wear test samples were prepared acc...
متن کاملFinite-element modeling of dry sliding wear in metals
This paper is concerned with the calibration and validation of a finite-element model of dry sliding wear in metals. The model is formulated within a Lagrangian framework capable of accounting for large plastic deformations and history-dependent material behavior. We resort to continuous adaptive meshing as a means of eliminating deformation-induced element distortion, and of resolving fine fea...
متن کاملThe role of dynamic recrystallization in dry sliding wear
• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website. • The final author version ...
متن کاملDry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Surface Science and Engineering
سال: 2016
ISSN: 1749-785X,1749-7868
DOI: 10.1504/ijsurfse.2016.077533