Dry Sliding Wear Behavior of Boron-Doped AISI 1020 Steels
نویسندگان
چکیده
منابع مشابه
Dry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملMechanical Properties of Boronized AISI 316, AISI 1040, AISI 1045 and AISI 4140 Steels
In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...
متن کاملComparison of Hardness and Wear Behaviour of Boronized and Carburized AISI 8620 Steels
In this study, the hardness and wear behaviour of carburized and boronized AISI 8620 steels have been studied. The boronizing treatment increased the hardness of AISI 8620 steels from 395 HV0.1 to a maximal 1610 HV0.1 compared to the carburized steels and also significantly improved its wear behaviour. From obtained results, it can be concluded that boronizing is very effective surface hardenin...
متن کاملDry Sliding Wear Behavior of Ti6Al4V and TaN against TiN Deposited Steel Surface
The objective of this research is to study the dry sliding wear behaviour of metal surfaces and influences of their surface hardness. The improved hardness of the TiN deposited surface was about 1763 Hv. The worn surface Scanning Electron Microscope (SEM) morphology exhibits the surface damage due to varying wear test parameters. The Electron Dispersive Spectroscopy (EDS) reveals that the mater...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Physica Polonica A
سال: 2017
ISSN: 0587-4246,1898-794X
DOI: 10.12693/aphyspola.132.455