Dry Sliding Behavior of an Aluminum Alloy after Innovative Hard Anodizing Treatments
نویسندگان
چکیده
منابع مشابه
Improved Technology for Hard Anodizing Dissolution of Aluminum Alloy Part
This paper deeply analyzes the main factors of the dissolved problems arising in the process of aluminum alloy hard anodizing, combined with the specific problems occurring in production practice, introduces in detail the method and thought to analyze and investigate the causes of dissolving, and puts forward targeted improvement technology. This paper is practically instructive and significant...
متن کاملEFFECTS OF Al-5TI-1B MASTER ALLOY AND HEAT TREATMENT ON THE MICROSTRUCTURE AND DRY SLIDING WEAR BEHAVIOR OF AN Al-12Zn-3Mg-2.5Cu ALLOY
In this study the effect of Al–5Ti–1B grain refiner on the structural characteristics and wear properties of Al–12Zn–3Mg–2.5Cu alloy was investigated. The optimum amount for Ti containing grain refiners was selected as 2 wt.%. T6 heat treatment, (i.e. heating at 460 °C for 1 h before water quenching to room temperature and then aging at 120 °C for 24 h) was applied for all specimens before wear...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملDry Sliding Tribological Behavior of TC11 Titanium Alloy Subjected to the Ultrasonic Impacting and Rolling Process
The dry sliding friction and wear behaviors of TC11 titanium alloy subjected to the ultrasonic impacting and rolling process (UIRP) were studied in the present work. The microstructure of the deformation layer and the morphology of the worn surfaces were observed. The results clearly show that the wear performance of TC11 alloy after UIRP is better than that of TC11 alloy before UIRP under the ...
متن کاملFast Anodizing of Aluminum Piston Heads
Hard anodizing of aluminum piston heads for internal combustion engines Is usually performed by immersion, with a time ranging from 40 to 50 minutes. This paper wii i present a new process, based on specially adapted hydrodynamics of the electrolyte, applying electrolysis parameter values outside the usual range and which greatly reduce the treatment time. In addition to applications to other c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2021
ISSN: 1996-1944
DOI: 10.3390/ma14123281