Dry friction avalanches: Experiment and theory
نویسندگان
چکیده
منابع مشابه
Rubber friction: comparison of theory with experiment.
We have measured the friction force acting on a rubber block slid on a concrete surface. We used both unfilled and filled (with carbon black) styrene butadiene (SB) rubber and have varied the temperature from -10 °C to 100 °C and the sliding velocity from 1 μm/s to 1000 μm/s. We find that the experimental data at different temperatures can be shifted into a smooth master-curve, using the temper...
متن کاملDynamics of dry granular avalanches.
A fine analysis of the statistics of dry granular avalanches in a rotating drum setup reveals that, beyond the fluctuations, the angle at which an avalanche ends is correlated experimentally to the angle at which the avalanche starts. This correlation resulting from inertia defines an intermediate "neutral" angle that characterizes the corresponding granular pile. In addition, an intensive stud...
متن کاملFriction at atomic-scale surface steps: experiment and theory.
Experiments performed by friction force microscopy at atomic-scale surface steps on graphite, MoS2, and NaCl in ambient conditions are presented. Both step-down and step-up scans exhibit higher frictional forces at the edge, but distinguish in their load dependence: While the additional frictional force due to the step edge increases linearly with load if the tip has to jump a step up, it remai...
متن کاملTowards a statistical theory of solid dry friction
Wearless dry friction of an elastic block of weight N , driven by an external force F over a rigid substrate, is investigated. The slider and substrate surfaces are both microscopically rough, interacting via a repulsive potential that depends on the local overlap. The model reproduces Amontons’s laws which state that the kinetic friction force is proportional to the normal loading force N and ...
متن کاملSurface roughness and dry friction.
Persson's multiscale contact mechanics theory combined with a multiscale Brillouin-Prandtl-Tomlinson model is used to show that on the basis of these models "dry friction" [i.e., kinetic friction that remains at exceedingly small velocities (but still above the creep range) close to its value at higher velocities] should almost always occur for self-affine surfaces when the dominant interaction...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review E
سال: 2006
ISSN: 1539-3755,1550-2376
DOI: 10.1103/physreve.74.066110