Dry adhesive bonding of nanoporous inorganic membranes to microfluidic devices using the OSTE(+) dual-cure polymer
نویسندگان
چکیده
منابع مشابه
Adhesive-based bonding technique for PDMS microfluidic devices.
We present a simple and inexpensive technique for bonding PDMS microfluidic devices. The technique uses only adhesive tape and an oven; plasma bonders and cleanroom facilities are not required. It also produces channels that are immediately hydrophobic, allowing formation of aqueous-in-oil emulsions.
متن کاملConstruction of microfluidic chips using polydimethylsiloxane for adhesive bonding.
A thin layer of polydimethylsiloxane (PDMS) prepolymer, which is coated on a glass slide, is transferred onto the embossed area surfaces of a patterned substrate. This coated substrate is brought into contact with a flat plate, and the two structures are permanently bonded to form a sealed fluidic system by thermocuring (60 degrees C for 30 min) the prepolymer. The PDMS exists only at the conta...
متن کاملCompliant and low-cost humidity nanosensors using nanoporous polymer membranes
This paper proposes non-fragile compliant humidity nanosensors that can be fabricated inexpensively on various types of nanoporous polymer membranes such as polycarbonate, cellulose acetate, and nylon membranes. The nanosensor contains a pair of interdigitated electrodes deposited on the nanoporous polymer membranes. The resistance and/or capacitance between these electrodes vary at different h...
متن کاملNanoporous Organic Polymer/Cage Composite Membranes**
Nanoporous organic polymer/cage composite membranes SUPPORTING INFORMATION
متن کاملBonding of microfluidic devices fabricated in polycarbonate.
A simple method for bonding polycarbonate, based on controlled exposure of the pieces to vapours of solvents, yields a tight seal and unmodified geometry of the channels.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Micromechanics and Microengineering
سال: 2013
ISSN: 0960-1317,1361-6439
DOI: 10.1088/0960-1317/23/2/025021