Drag and lift reduction of a 3D bluff-body using active vortex generators

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Drag reduction of a bluff body using adaptative control methods

HAL is a multi-disciplinary open access archive for the deposit and dissemination of scientific research documents, whether they are published or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers. L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau...

متن کامل

Bluff Body Noise Reduction Using Aerodynamic Interference

Abstract This paper will discuss a method of bluff body noise control that utilises the phenomenon of aerodynamic interference. This technique uses a second body (not necessarily bluff) that is placed in the wake of the bluff body whose noise we wish to control. Through proper understanding of the wake dynamics, the amplitude and phase of the noise from the downstream body can be controlled so ...

متن کامل

EXPERIMENTAL INVESTIGATION OF DRAG REDUCTION ON AHMED MODEL USING A COMBINATION OF ACTIVE FLOW CONTROL METHODS

Aerodynamic drag is an important factor in vehicles fuel consumption. Pressure drag which is the main component of total drag is a result of boundary layer separation from vehicle surface. Flow control methods are applied to avoid or at least delay separation. Depending upon whether these methods consume energy to control the flow or not, they are called active or passive control methods. In th...

متن کامل

Test and Verification of Vortex Shedding for a 3D bluff body

Testing of a 3D bluff body with and without end plate tabs was performed in the California Polytechnic State University 3x4 ft low speed wind tunnel. The CP values were obtained for the test case with no end plate tabs for speeds of 10, 15, 20, and 30 m/s. It was observed that stronger vortex shedding ocured at the higher speed test cases. The model was shimmed to be at approximately 5° angle o...

متن کامل

Vortex penalization method for bluff body flows

In this work, a penalization method is discussed in the context of vortex methods for incompressible flows around complex geometries. In particular, we illustrate the method in two cases: the flow around a rotating blade for Reynolds numbers 1000 and 10,000 and the flow past a semi-circular body consisting of a porous layer surrounding a rigid body at Reynolds numbers 550 and 3000. In the latte...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Experiments in Fluids

سال: 2009

ISSN: 0723-4864,1432-1114

DOI: 10.1007/s00348-009-0770-y