Doherty Amplifier Design Based on Asymmetric Configuration Scheme
نویسندگان
چکیده
منابع مشابه
A Tradeoff Design of Broadband Power Amplifier in Doherty Configuration Utilizing a Novel Coupled-Line Coupler
A broadband power amplifier designed and implemented in Doherty configuration is illustrated in this paper. Both input and output networks adopt the broadband matching topology. Additionally a compensation network, consisting of a series transmission line shunted with a capacitance, is set behind the peak amplifier to avoid in-band power leakage in the low-power section while at the cost of pea...
متن کاملTowards generalized Doherty power amplifier design for multiband operation
This paper presents a new variant of broadband Doherty power amplifier that employs a novel output combiner. A new parameter αα is introduced to permit a generalized analysis of the recently reported Parallel Doherty power amplifier (PDPA), and hence offer design flexibility. The circuit prototype of the new DPA fabricated using GaN devices exhibits maximum drain efficiency of 85% at 43-dBm pea...
متن کاملModified Doherty Power Amplifier for Wider Band
Wireless communication system are developing rapidly, due to which new standards like WIMAX and 4G Long Term Evaluating(LTE) with a purpose of achieving high data rate result in high end applications such as high speed internet, video conferences and broadband width. These applications require mobile base stations at the transmitter as well as at receiver (T/R) to support features like multiple...
متن کاملLinearization of Three-Stage Doherty Amplifier
In this paper, the operational behavior of three-way Doherty amplifier loaded with harmonic control circuits is analyzed, including the efficiency and linearity. Amplifier is designed in configuration with two quarter-wave impedance transformers in the output combining circuit with LDMOSFETs in carrier and peaking amplifiers with the same periphery and in periphery relations 1:2.5:2.5. The sign...
متن کاملMillimeterwave INP DHBT power amplifier based on poweroptimized cascode configuration
This letter describes the use of a power-optimized cascode configuration for obtaining maximum output power at millimeter-wave (mm-wave) frequencies for a two-way combined power amplifier (PA). The PA has been fabricated in a high-speed InP double heterojunction bipolar transistor technology and has a total active emitter area of 68.4 lm2. The experimental results demonstrate a small signal gai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Transactions on Electronics
سال: 2021
ISSN: 0916-8524,1745-1353
DOI: 10.1587/transele.2021mmi0002